5 min read

EC-Lab Technical Notes 36: Board validation

Latest updated: May 6, 2020

Introduction

The modularity of BioLogic instruments means that users may add additional channel(s) after an experiment has started to run. The board installation can be validated in two steps:
• Firstly, we recommend that you calibrate the channel with the calibration tool available in the EC-Lab® tools menu. The procedure is described at the end of the “Installation & configuration manual” [1] and also in the Technical Note #18 [2].
• If a further check is needed, it is possible to validate the boards using the dummy cells provided with the board(s).

Related files

EC LAB TN36 Boards validation

You cannot access this resource because you are not logged in. Log in

Related products