Purge and bridge tubes for analytical cells
The bridge tubes allow to prevent the reference electrode from being contaminated by the electrolyte. Purge tubes are used to control the gas concentration in and above your electrolyte.
Bridge tubes are used to avoid direct contact of the reference electrode with the electrolyte. Also it ensures a very short distance between the reference and the working electrode, minimizing the ohmic drop. Purge tubes are used when the electrolyte needs to be oxygen-free. Usually one uses an inert gas such as argon or nitrogen to purge the solution and also create an oxygen-free environment on top of the electrolyte, preventing air to enter the cell. Two bridge tubes are available: one can accommodate 6 mm diameter reference electrode and the other 8 mm diameter reference electrode. Two purge tubes are available: one has a single tube and the other is double-walled to allow the user to blanket the electrolyte.
Specifications and ordering information
|Bridge tube for
|8 mm||EL-A-017||10 mm||165 mm||1||EL-ELECTRO|
|6 mm||EL-A-008||10 mm||155 mm||1||EL-ELECTRO|
|Purge tube for
|10 mm||165 mm||1||EL-ELECTRO|
|10 mm||200 mm||1||EL-ELECTRO|
|Set of 10 porous glass frits diameter 2.8 mm (CoralPor) + high temperature heat shrink PTFE (20 cm, ID 3.2 mm)||092-VYC3|
|Set of 10 porous glass frits diameter 2.8 mm (CoralPor) + low temperature heat shrink PVDF (20 cm, ID 3.2 mm)||092-VYC3A|